What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 02:01

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
One
2024–10–10[John johnson John Johnson ]
How was your first cuckolding experience as a husband?
eight
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Edit 2024–10.
If Trump were to lose in 2024, would that be the end of his grip on the Republican Party?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
It seems Mohan does not understand the difference between a comment and an Answer.
How did you get to be a leftist?
These are simplified answers to the original question, and does not change anything I wrote above.
Now when you have a certain ac resistance, then a current flows in a loop.
He then asserts :
Bitcoin Price (BTC) News: Testing $110K Level Again - CoinDesk
This one hit behind the barn.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
a photo is worth a thousand words.
What toxic behavior has been normalized by society?
The third is lightning and “how it gets conducted into a home.”
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
the problem then depends on "how fast does the fuse operate?".
I post the exact comment here.
Upvotes:
Patch Notes: New Co-op Emotes! — Warcraft Rumble - Blizzard News
but I think this circuit , shows a few more pieces.
Here is a simplified AC power diagram.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
[image of Common-mode choke]
so, what happens?
In what ways does Islam oppress women?
This is 'the assistant's answer'
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
So, the voltage could go up to 500 volts, and the fuse will not open up.
New Study Finds 1 Promising Way To Keep Colon Cancer From Returning - HuffPost
but this device (an Inductor) … impedes the rapid changes in the current.
A circuit breaker is similar, but is resettable.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Star-shaped brain cells may underpin the brain's massive memory storage - Live Science
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
What is lightning?
How did Kate Mulgrew feel about Jeri Ryan joining the cast of Star Trek: Voyager?
(Dc diagram shown, AC is similar).
These devices are installed between the “hot” and “neutral” and protective ground.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
what exactly is a ‘surge’ protector?
He then describes the function of a fuse.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
At one ohm, the resistor has a maximum of 1 watt power.
Barnstars:
There are three different concepts here that are getting confused.
A fuse is a non-resetable over current circuit protector.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The other is “what does a “fuse” do?”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
He then describes Rainy Season and Lightning.
What does a fuse do?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–16 [ OO OLAOYE OYEBODE ]
The bolt then partially travels down the line to your home.
One is “what exactly is in a ‘surge protector’ ? ”
This device then solves the entire problem.
But it can get overloaded, and no longer works.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
nine
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
There are two important concepts here.
An AC voltage/ current source, and an ac inductive load.
In schematic diagrams this is the symbol for a fuse:
[old diagram got deleted by accident]
Because the load is inductive, the current lags the voltage.(by a bit).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
At least they know the answer if they wanted it.
First Sentence:
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
For this case there are devices called Metal oxide varistors (MOV).
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
The MOV will conduct when the voltage exceeds 50% of line voltage.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is where the MOV conducts again, and dissipated the energy.
It also is a device that limits the change in current flow.